Solid Carbide Router Bit - Spiral Compression Top & Bottom Bearing - D=19mm H1=16mm H2=16mm S=1/2"

Solid Carbide Router Bits
Each router bit has been precision ground from a single piece of super micro-grain solid tungsten carbide. This ultimate micro-grain carbide formulation gives the longest tool life and edge retention ensuring a very clean and accurate cut that leads to the ultimate finish. These STC router bits are suitable for use on softwoods, hardwoods, veneers, plastic materials, laminates, and composite materials.

Spiral Compression Two Flute with Top and Bottom Bearing Bits
Spiral compression two flute bits leave the ultimate finish when using templates. Having a bearing on both the top and bottom means you can use a template on either side of your workpiece. The compression bits feature both up and down shear cutting edges on the same bit to provide down-cutting on the top faces of material and up-cutting on the bottom. This action pulls fibres towards the centre of the board, eliminating tearing & chipping, whilst ensuring an ultra fine finish on both faces.

Superior Finish and Performance
Each spiral has been specifically designed to give the optimum cutting angle to ensure the wood is sheared cleanly as well as providing efficient chip ejection. This leads to the bits running cooler during use as solid carbide dissipates heat more uniformly, even at high speeds, meaning the edges remain as sharp as possible and are retained for longer. Each bit conforms to strict German DIN standards to ensure maximum operator safety. ©